Stretch Stitch Feed Balance - ELNA eXperience 660 Service Manual

STRETCH STITCH FEED BALANCE

WHEN A STRETCH PATTERN IS SEWN WITH THE FEED BALANCING DIAL (C) SET AT THE
STANDARD MARK, THE PATTERN SHOULD BE AS INDICATED WITH THE "O".
1. Set up the machine in adjusting mode (see below).
2. Set the feed balancing dial at the standard setting mark.
3. Check the sewing results (the standard figure length of five pieces of figure 8 is 33–39 mm).
4. Remove the 2 setscrews. Then remove the base cap.
5. If the length is longer than 39 mm, turn the adjusting screw in the direction of (C).
6. If the length is shorter than 36 mm, turn the adjusting screw in the direction of (D).
7. Reattach the base cap and tighten the setscrews.
TO ENTER THE ADJUSTING MODE
Turn the power switch on while pressing
the up/down needle position button and
auto-lock stitch button.
Standard setting
mark
36–39mm
Press the button 8.
Feed balancing dial
Adjusting screw
19
MODEL:eXperience 660
Feed Adjustment
Sew Stop
Base cap
C D Setscrew