Table of Contents
Advertisement
KBN & KBE Series Cameras
5
Installation of KBN (Indoor) Cameras
WARNING!
This installation should be made by a qualified service person
and conform to all local codes.
1.
NOTICE!
If you plan to route cables out the back of the mount, ensure
that the placement of the mount allows space behind the
mounting surface to route and connect wires.
2.
5.1
Connecting Analog Cameras
1.
Figure 5.1 Cable Routing Options
2.
Bosch Security Systems, Inc.
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
Prepare and secure the mount to the wall or mounting
surface as described in the LTC 9215/00 Installation
Manual included in the Instruction Booklet Packet.
Follow the steps in the subchapters below, depending on
the model of camera that you are installing (analog or IP).
Connect the male BNC connector to the female BNC
connector routed through either the back end or through
the bottom hole of the mount.
or
Make the power connections as detailed in Section Power
Connections, page 19.
Installation Manual
Installation of KBN (Indoor) Cameras | en
F.01U.215.198 | 4.0 | 2011.01
21
Advertisement
Table of Contents
