62
en | Preparing the Wiring
8.2
Connecting the Power
The AutoDome Easy II is available as an indoor or as an outdoor
model. All indoor models contain a single power connector for
the camera.
The outdoor models contain two isolated power connectors,
one for the camera (red and black wires) and one for the heater
(white/red and white/black wires).
NOTICE!
Use certified / Listed Class 2 power supply transformer only.
Determining Power Connections
The table below summarizes the necessary power connections
for indoor and outdoor analog models. Use the table to identify
the necessary connections and for direction to the proper
section.
Model
Analog
Indoor
Outdoor 24 VAC
8.2.1
Power Connections to Indoor Cameras
Figure 8.1 Power Cable
Ref. # Wire
1
2
3
F.01U.164.478 | 2.0 | 2010.02
Connection
24 VAC / 12 VDC
24 VAC to heater
24 VAC / +12 VDC
24 VAC/GND
User supplied Power Supply
Installation Manual
Refer to
Section 8.2.1 Power Connections to Indoor
Cameras, page 62
Section 8.2.2 Power Connections to Outdoor
Cameras, page 63
Section 8.2.3 Power Connections to Heater
(all outdoor models), page 64
Color
Red
Black
n/a
Bosch Security Systems, Inc.
AutoDome Easy II