Panasonic EP1014-U1 Service Manual page 31

http://202.224.189.178/~sgml/viewing/EP1014-U1/NA/SVC/s0902000000.html
9.2 Removing the massager
TOP PREVIOUS NEXT
1. Remove the two installation screws from the massager cover, and take off the cover and remove
the Cover clip.
*Cover clip is available to remove only after taking off the cover.
2. Remove two snap pins connecting Ottoman Power Lift Unit and Connecting Linkage to Back
frame, and push down the seatback to the front part for easy repaire.
*Inspection and repair are done after placing the chair as explained in 1. and 2. above.
3. Remove the rail piece set screws , 3 pieces (left and right) shown in Figure, and remove the rail
pieces A and B.
4. When the massager moves up and down (normally), move it down to the lowest position by
setting the controller manual operation up/down button to "DOWN", and then turn clockwise the
up/down clutch hex nut M6 (see Figure) tomove to the position where the Pinion A and B block is
visible from the back frame.
*When the massager fails to move up and down, turn clockwise the hex nut M6 of up/down
clutch.
(The massager can be moved by attaching the hex socket ø10 (for nut 6 mm) to a rechargeable
drill driver.)
5. Cut the cable tie as shown figure and remove the two connectors (red, white) of the connecting
cord for power supply and the connecting cord for controller connected massager and unscrew the
ground cord of the connecting cord for power supply, removeone screw fixing the massager side
cord Fitting B and Cord wire D and remove two cords from the massager.
6. Slide out the massager mechanism carefully.
http://202.224.189.178/~sgml/viewing/EP1014-U1/NA/SVC/s0902000000.html (1 of 5) [12/6/2003 9:48:49 AM]