Parameter Setting; Maintenance Mode; Introduction - YOKOGAWA SC202G User Manual

5. PARAMETER SETTING

5-1. Maintenance mode

5-1-1. Introduction

Standard operation of the EXA instrument involves use of the Maintenance (or operating) mode to set up
some of the parameters.
Access to the maintenance mode is available via the six keys that can be pressed through the flexible
window in the instrument front cover. Press the "MODE" key once to enter this dialog mode.
(Note that at this stage the user will be prompted for a passcode where this has been previously set up
in service code 52, section 5)
Calibrate : See "calibration" section 6.
Display setting : See "operation" section 4.
Hold : Manually switch on/off "hold" (when enabled in commissioning menu). See adjustment
mA mA 5-1-2. Manual activation of Hold
YES
procedure 5-2-3.
MODE
FAIL
MEASURE
OUTPUT
SET HOLD
TEMP.
SERVICE
NO MODE
ENT
MODE
M W .c m
CALIBRATE
YES NO
NO
NO
NO
M W .c m
YES
YES NO
NO
NO
M W .c m
YES
YES NO
Parameter setting 5-1
HOLD
M ½ .c m
YES NO
YES
NO
HOLD
M ½ .c m
MEASURE
IM 12D08B02-01E