Table of Contents
Advertisement
Basic Operation
Remote Transmitter Layout:
Each system comes with 2 Remote Transmitters, pre-programmed to operate in the Standard Mode and will Arm and Disarm
the system with chirp confirmation.
Button 1 Arms the system. This Button also locks the doors when the system is in Valet Mode.
Button 2 Disarms the system. This Button also unlocks the doors when the system is in Valet Mode.
Button 3 Activates the the systems trunk release feature. Silently arms/disarms the system.
Optional Driver Door Priority Feature*
This configuration adds the security of unlocking only the driver's door when the system is Disarmed. Pressing the Disarm
button again will unlock all remaining doors.
Button 1 Arms the system. This Button also locks the doors when the system is in Valet Mode.
Button 2 Disarms the system and unlocks the driver's door. This Button also unlocks the doors when the system is in Valet
Mode.
If the system is Armed, pressing Button 2 will Disarm the system and unlock the driver's door only.
If the system is Disarmed, pressing Button 2 will unlock all remaining doors.
If the system is in Valet and the doors are locked, pressing Button 2 will unlock the driver's door. Pressing Button 2 again
will unlock all remaining doors.
*Extra parts and/or labor may be required to properly utilize this feature.
Remote Arming
When Armed, the system monitors and protects 4 independent areas, or zones, including the doors, hood/trunk, shock sensor
and optional sensor.
To Arm the System:
1. Turn off the ignition.
2. Press Button 1.
• The siren/horn will chirp once.*
• The doors will lock.
• The parking lights will flash once.
• The LED will turn on red, indicating the doors, hood and trunk inputs are activated
* The siren chirp(s) during Arming will alert you the condition of the system and vehicle when the system is armed.
1 chirp
=
normal arming
1 + 4 chirps =
door, hood, or trunk open
During Arming, if the system detects a bad sensor or an open zone, the system will ignore that input, but keep all other
areas protected.
3. After 10 seconds:
• The LED will begin blinking, indicating that the sensor inputs are activated.
While the system is Armed, the system will trigger if:
• The doors are opened.
Page 5 - G1100 Installation Manual
LED
Button 1
Button 3
Button 2
.
Advertisement
Table of Contents
