Table of Contents
Advertisement
Programming
Entering System Programming
To enter System Programming:
1. Turn on ignition.
2. Within 5 seconds, press the valet switch 5 times.
• The siren will emit a buzzing sound, indicating that you have entered Programming.
3. Press the valet switch the number times equal to the System Parameter you want to change.
• The siren will chirp each time the valet switch is pressed.
4. Within 5 seconds, press the transmitter button corresponding to the desired operating mode for that System
Parameter.
• The siren will chirp to indicate the setting.
1 chirp
=
2 chirps
=
3 chirps
=
5. When you are finished, turn the ignition key off to save the changes. You can turn the key off at any time during
programming and the changes that were made will be saved.
System Initialization and Default Reset
Following this procedure will set all System Programming Parameters to factory default settings.
1. Enter System Programming.
2. Press Transmitter Button 3.
• The siren will chirp 6 times indicating that the reset signal was received.
• All System Programming parameters are now set to factory default settings.
• The Arming Mode is set to Remote Arming only.
• The Valet Mode is off.
• The Disarm Code is 1.
3. Turn ignition off.
Programmable System Parameters
Feature
1
Ignition Controlled Door Locking
2
Ignition Controlled Door Unlocking
3
Door Unlock Pulse
4
Door Lock Pulse Width
5
Passive Locking
6
Door Entry Delay with Passive Arming
7
Ignore Dome Light Delay
8
Auto Rearm
9
Horn Honk / Arming Output
10
Trunk Disarm Feature
11
Siren / Horn Chirps
1. Ignition Controlled Door Locking. Selects whether or not the system automatically locks the doors when the ignition is
turned on. When selected, the Ignition Controlled Door Locking feature will automatically lock the doors 10 seconds after the
ignition key is turned on.
To prevent the keys from being locked inside the vehicle when Ignition Controlled Door Locking is on:
• The system will not lock the doors if any door is open when the ignition is turned on.
• The system will not lock the doors if any door is opened during the 10 second countdown.
2. Ignition Controlled Door Unlocking. Selects whether or not the system automatically unlocks the doors when the ignition
is turned off. When selected, the Ignition Controlled Door Unlocking feature will automatically unlock the doors when the
ignition key is turned off.
3. Door Unlock Pulse - Single/Double. Selects between a single pulse or a double pulse door unlock output.
On many late model Nissan vehicles, as well as some European makes, the factory door locking system requires two pulses
Button 1
Button 2
Button 3
Button 1 (default)
On
On
Single
1 second
Off
Off
Off
Off
Continuous
Off
Siren only
Button 2
Button 3
Off
Off
Double
4 seconds
On
On
Ignore
On
Flashing
On
Horn chirps
G1100 Installation Manual - Page 10
Advertisement
Table of Contents
