Table of Contents
Advertisement
3.12 Valet Mode
When placed into Valet Mode the security system will be disabled. However, the
optional keyless entry and auxiliary outputs will still function if installed.
To enter the Valet Mode:
1. Be sure the alarm system is disarmed.
2. Press and hold the Valet/Override button.
3. Turn the ignition On.
4. Continue holding the Valet/Override button for 3 seconds.
5. Turn the ignition Off.
• The siren will chirp once.
• The LED will turn On solid indicating the system is in Valet mode.
To exit Valet Mode:
1. Press and hold the Valet/Override button down.
2. Turn the ignition On.
3. Hold the Valet/Override button for 3 seconds.
4. Turn the ignition Off.
• The siren will chirp twice.
• The LED will turn off indicating the system is out of Valet mode.
3.13 Optional Trunk Release
Press the Trunk button for approximately 3 seconds to open the trunk. This
optional feature may require addtional parts and labor, consult your Authorized
Ungo dealer for more information.
3.14 Optional Trunk Disarm Feature
The trunk disarm feature allows the alarm to disarm automatically when the Trunk
button is used to activate the optional trunk release. This eliminates having to
disarm the alarm system prior to activating the trunk release. This optional feature
may require addtional parts and labor, consult your Authorized Ungo dealer for
more information.
3.15 Programming Remote Transmitters
Make sure to have the desired transmitters ready and follow the steps below.
To program transmitters:
1. Turn the ignition ON, OFF, ON, OFF, and leave ON.
2. Press and hold the Valet/Override switch for 5 seconds.
• The siren will chirp once.
9
Advertisement
Table of Contents
