Multi-Step Speed Command; Jog Operation Control - Delta VFD-L series User Manual

VFD-L Series
Note: the External Reset has the same function as the MODE/RESET key on the Digital
keypad. After external fault such as O.H., O.C. and O.V. are clear, this input can be
used to reset the drive.
d7, d8 Multi-Step Speed Command:
Parameter values d7, d8 programs any two of the following Multi-Function Input Terminals:
M1 (Pr.4-04), M2 (Pr.4-05), or M3 (Pr.4-06) for multi-step speed command function.
These three inputs select the multi-step speeds defined by Pr.5-00 to Pr.5-02 as shown in
the following diagram. Pr.5-05 to Pr.5-8 can also control output timing by programming
¶
the AC drive s internal PLC function.
d9 Jog Operation Control:
Parameter value d9 programs Multi-Function Input Terminal: M1 (Pr.4-04), M2 (Pr.4-05)
or M3 (Pr.4-06) for Jog control.
D 7 M u lti-s te p 1
M x " C lo s e " : O p e ra tio n a v a ila b le
M x " C lo s e " : O p e ra tio n a v a ila b le
D 8 M u lti-s te p 2
G N D
P r.5 - 0 0
F re q .
S te p 1
M a s te r F r e q .
O N
M x 1 -G N D
M x 2 -G N D
O p e ra tio n
C o m m a n d
M x " C lo s e " : O p e ra tio n a v a ila b le
d 9 jo g o p e ra tio n
c o m m a n d
G N D
P r.5 - 0 1
S te p 2
P r.5 - 0 2
S te p 3
T im e
O N
O N O N
O N O F F
5-22
DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED