Paper Feed
6.
By-pass friction pad [G]
Pull up the edge of the by-pass friction pad ( ).
Pull the by-pass friction pad forward. When you do this, hold down the edge where its
shaft is located ( ).
Reassembling the by-pass friction pad
1.
Place the spring [H] on the projection [I] of the by-pass tray.
2.
Hold down the by-pass friction pad after you put the spring on the projection of pad's
reverse side ( ).
3.
Release the by-pass tray friction pad when it passes through the bushing [J].
4.
Pull up the shaft of the by-pass friction pad to the busing until it is clicked.
G190
3-24
SM