Attach Front Section - Teledyne MB1 Hardware Manual

MB1
User Manual
The rear top section in place before attaching
4.6.5

Attach Front Section

The front section is best attached with the unit sitting flat (transdcuer face down) on a table with the front
of the unit pointing towards you. Take the front section and position it over the front of the MB1. Take the
two long Hex bolts, thread each with a split and regular washer, then insert them into the uppermost two
holes of the section. Hand tighten. Repeat this step with the two smaller bolts for the lower two holes of
the section. The fairing is now complete.
Front section and hardware
Page 26 of 37
7/6/12