Attach Rear Top Section - Teledyne MB1 Hardware Manual

MB1
User Manual
Rear Section Placed on MB1 (left) and bolted (right)
4.6.4

Attach Rear Top Section

Next take the rear top section and thread the Power/Data cable through the cut out hole in the top.
Thread the Digibar V cable (if used) through the small cable cutout on the side of the rear section to one
side. Place the rear top section on top of the rear section. Take the 3 Hex screws and thread each one
with a split washer and a regular washer, then screw the top to the rear section using the 3 holes
provided.
The rear top section (below) and hardware
Page 25 of 37
7/6/12