Gather Required Tools And Parts; Connect The Power/Data Cable And Digibar V Cable (If Used) To The Mb1; Attach Rear Section - Teledyne MB1 Hardware Manual

MB1
User Manual
4.6.1

Gather Required Tools and Parts

The Fairing is supplied as a kit, consisting of 3 black semi rigid parts, 8 Titanium Hex bolts, 3 Hex Screws,
and associated washers. Two allen (Hex) keys will be required for assembly - one 3/16" and one 5/32".
4.6.2

Connect the Power/Data Cable and Digibar V Cable (if used) to the MB1

4.6.3

Attach Rear Section

With the MB1 placed on it's end, slide the rear section onto the back of the MB1, with the grooved part in
line with the bottom of the sonar. Thread the 4 long Hex bolts with a split ring and regular washer each.
Push these bolts into the 4 holes on the back of the rear section and hand tighten using the 3/16" Hex
key.
Fairing Kit (front portion Hex Bolts not Shown)
Power Data Cable attached
Page 24 of 37
7/6/12