Working With Iop - Siemens SINAMICS G120 Manual

Working with IOP

The IOP is operated mainly by using the push-wheel. The five additional buttons make it possible
to display certain values or to switch between manual and auto mode. The buttons are called: ON
key, OFF key, ESC key, Info key, and HAND / AUTO key.
Operator Panels BOP-2 and IOP:
34
4 5
1
3 6 2
Intelligent operator panel
1 Turning changes the selection
Pressing confirms the selection
2 Starts the motor in manual mode
3 Stops the motor in manual mode
Takes you back to the previous
4
screen
5 Displays additional information
Switches the command source
6
between HAND and AUTO mode
The HAND/AUTO function
works the same as the one
implemented in the BOP-2.
After starting the motor
with the ON button, you
can change the setpoint
speed by navigating to
CONTROL/SETPOINT and
turning the wheel (right
to increase speed, left to
decrease speed).
Note