Entering Motor Data - Siemens SINAMICS G120 Manual

Entering motor data

The values for the next parameter settings can be found on the rating plate of your motor.
Please set the motor data parameters according to the picture below.
Once the motor rated speed has been adjusted, you have completed
adjusting your inverter to your motor.
Operator Panels BOP-2 and IOP:
26
1 2 3 4
Quick commisioning
1 P304 = MOT VOLT = Motor voltage
2 P305 = MOT CURR = Motor rated current
3 P307 = MOT POW = Motor rated power
P311 = MOT RPM = Motor rated speed
4
If you want to adjust any
blinking/active value digit
by digit (using the UP and
DOWN button might just
Euismvod tincidunt ut laoreet dolore
take too long) you can
magna aliquam sit tecum am!
always press the OK button
Consectetuer adipivscing elit, etesse
longer than two seconds.
molestie consequat, vel illum dolore
After releasing the button
eu feugiat nulla facilisis at vero eros
you can change any single
et accumsan et iusto odio dignissim
digit by using the buttons
qui blandit praesent luptatdelenit
OK (move to next digit),
augue duis dov.
ESC (move to previous
digit), UP (increase value) lore te feugait um zzril delenit ad
and DOWN (decrease ullamcorper suscipit lobortis nisl ut
value). aliquip ex ea commod.
Note