Cautions; Authorized Service Centers - Fluke 9103 User Manual

1.2.2
1.3
info@Fluke-Direct.com
DO NOT use this unit for any application other than calibration work.
DO NOT use this unit in environments other than those listed in the user's
guide.
DO NOT turn the unit upside down with the inserts in place; the inserts will
fall out of the unit.
DO NOT operate near flammable materials.
Use of this instrument at HIGH TEMPERATURES for extended periods of
time requires caution.
Completely unattended high temperature operation is not recommended for
safety reasons.
Before initial use, after transport, and anytime the dry-well has not been ener-
gized for more than 10 days, the calibrator must be energized for a dry-out pe-
riod of 1 to 2 hours before it can be assumed to meet all of the safety
requirements of the IEC1010-1.
Follow all safety guidelines listed in the user's manual.
Calibration equipment should only be used by Trained Personnel.

Cautions

To avoid possible damage to the instrument, follow these guidelines.
• Components and heater lifetime can be shortened by continuous high
temperature operation.
• Allow for test probe expansion inside the well as the dry-well heats.
• DO NOT use fluids to clean out the well.
• Never introduce foreign material into the probe hole of the insert. Fluids,
etc. can leak into the calibrator causing damage.
• DO NOT change the values of the calibration constants from the factory
set values. The correct setting of these parameters is important to the
safety and proper operation of the calibrator.
• DO NOT slam the probe stems into the well. This type of action can
cause a shock to the sensor and affect the calibration.
• DO use a ground fault interrupt device.

Authorized Service Centers

Please contact one of the following authorized Service Centers to coordinate
service on your Hart product:
Fluke Corporation, Hart Scientific Division
Fluke-Direct
1 Before You Start
Authorized Service Centers
.com
1.888.475.5235
3