Display Setup - Crestron TSW-560 Supplemental Manual

•
Tap < BACK to return to the TSW-560/760/1060 Setup screen.

Display Setup

On the TSW-560/760/1060 Setup screen, tap Display Setup to display the Display Setup
screen.
Display Setup Screen
Use the Display Setup screen to adjust the LCD display and the key backlight settings.
The following settings can be adjusted for the LCD (screen) display:
•
•
•
The following settings can be adjusted for the hard key backlight:
•
•
•
•
8 • TSW-560/TSW-760/TSW-1060: 5", 7", and 10.1" Touch Screens
Beep Volume: Tap the up and down arrows to raise or lower the beep volume of
the touch screen, from 0 to 100%. Tap Beep On or Beep Off to turn the beep
volume on or off.
Tap the up and down arrows under Brightness to raise or lower the brightness
level of the LCD display, from 0 to100%.
Tap On or Off under Auto Brightness to enable or disable auto brightness on the
display.
Tap the left and right arrows to adjust the ALS (ambient light sensor) threshold
value for switching between high and low auto-brightness presets, from 0 to 100%.
Tap Enabled or Disabled under Hard Key Backlight to enable or disable the hard
key backlight.
Tap the up and down arrows under Brightness to raise or lower the brightness of
the hard key backlight.
Tap On or Off under Auto Brightness to enable or disable auto brightness for the
backlight.
Tap On or Off under Hard Key Wakes LCD to enable or disable waking the LCD
display by tapping a hard key.
Supplemental Guide – DOC. 7927A