Fluid Control Clutch; Specified Fluid; Fluid Level Check; Gear Oil Change - Suzuki Ciaz series Owner's Manual

INSPECTION AND MAINTENANCE
CAUTION
After driving the vehicle, the gear oil
temperature may be high enough to
burn you. Wait until the oil filler is
cool enough to touch with your bare
hands before inspecting gear oil
level.
NOTICE
When tightening the plug, apply the
following sealing compound
equivalent to the plug threads to pre-
vent oil leakage.
SUZUKI Bond No. "1217G"

Gear Oil Change

Since special procedures, materials and
tools are required, it is recommended that
you trust this job to your authorized
SUZUKI dealer.
7-19

Clutch Pedal

Fluid Control Clutch

or
Check the clutch pedal for smooth opera-
tion and clutch fluid level from time to time.
If clutch dragging is felt with the pedal fully
depressed, have the clutch inspected by
your SUZUKI dealer. If the clutch fluid level
is near the "MIN" line, fill it up to the "MAX"
line with SAE J1703 or DOT3 brake fluid.
Continuously Variable
Transaxle (CVT) Fluid

Specified Fluid

Use a CVT fluid SUZUKI CVT FLUID
GREEN-2.

Fluid Level Check

MAX
NOTICE
Driving with too much or too little
fluid can damage the transaxle.
MIN
You must check the fluid level with the CVT
fluid at normal operating temperature.
54MN132
To check the fluid level:
1) To warm up the CVT fluid, drive the
vehicle or idle the engine until the tem-
perature gauge indicates normal oper-
ating temperature.
2) Then drive for ten more minutes.
NOTICE
Be sure to use the specified CVT
fluid. Using CVT fluid other than
SUZUKI CVT FLUID GREEN-2 may
damage the CVT of your vehicle.
79MS0-14E