Suzuki Ciaz series Owner's Manual page 103

OPERATING YOUR VEHICLE
Starting a Cold and Warm Engine
With your foot off the accelerator pedal,
crank the engine by pressing the engine
switch to change the ignition mode to
"START".
NOTICE
Do not crank the engine for more
than 12 seconds at a time.
If the engine doesn't start on the first
try, wait about 15 seconds before try-
ing again.
After pressing the engine switch to change
the ignition mode to "START", the starter
cranks the engine for about 12 seconds
before it can start the engine. If the engine
fails to start at the first attempt, wait about
15 seconds, then try again while keeping
the engine switch pressed while pressing
down the accelerator pedal to 1/3 of its
travel. Release the accelerator pedal when
the engine starts.
If the engine still does not start, try holding
the accelerator pedal all the way to the
floor while cranking. This should clear the
engine if it is flooded.
If you are unable to start the engine using
this procedure, consult your SUZUKI
dealer.
3-15
If the "PUSH" indicator light blinks and
the engine cannot be started
Your keyless push start system remote
controller may not be sensed as being
within the "interior workable area". Try
again after making sure that you have the
remote controller with you. If the engine
still cannot be started, the battery of the
remote controller may be discharged. You
must then use the following method to be
able to start the engine.
EXAMPLE
(1)
(2)
1) Make sure the parking brake is set fully.
2) If the gearshift lever is not in the "P"
(Park) position, shift it to "P". Hold the
brake pedal fully depressed.
3) The "PUSH" indicator light in the instru-
ment cluster will come on. Press the
engine switch (1).
4) Within about 10 seconds of blinking of
the "PUSH" indicator light in the instru-
ment cluster, touch the engine switch
with the lock switch end of the remote
controller (2) for about 2 seconds.
79MS0-14E
57L21131