Hardware Installation - EnGenius ENS620EXT User Manual

Hardware Installation

1. Remove the rear bottom panel.
2. Connect one end of the Ethernet cable into the LAN(PoE)
port of the AP/Bridge and the other end to the PE port
on the PoE Adapter.
3. Connect the Power cord with the PoE Adapter and plug
the other end into an electrical outlet.
4. Connect the second Ethernet cable into the LAN port of
the PoE adapter and the other end to the Ethernet port
on the computer.
5. Place the pane removed from step A back into the
device.
6. Screw on the provided antennas to the top of this device.
This diagram depicts the hardware configuration.
1
1
5
Note: The Access Point NOLY supports the included
proprietary 24V PoE adapter.
16
3
2
3
2
4 2.4GHz
5GHz
6
2.4GHz
5GHz