Using Tridata Depth; Using Tridata Speed - Raymarine i50 Depth Installation And Operation Instructions Manual

8.9 Using Tridata depth pages
To cycle through the depth pages follow the steps
below.
De pth
De pth
De pth
1. Use the Depth button to cycle through the
available depth pages.
Available depth pages are:
• Current depth
• Shallow depth alarm
• Deep depth alarm
• Shallow anchor alarm
• Deep anchor alarm
Note: Alarm pages are temporary pages will
time-out after 8 seconds and revert to the Current
depth page.
To enable / disable alarms or to adjust alarm
thresholds please refer to the Alarms section.
i50 Tridata
8.10 Using Tridata speed pages.
To cycle through the speed pages follow the steps
below.
De pth
S pe e d
De pth
D12538-2
1. Current Speed page
2. [1] Maximum Speed page
3. [1] Average Speed page
4. [2] VMG page
Note:
• [1] These pages are temporary pages and will
revert back to the previous permanent page
after 8 seconds of inactivity.
• [2] The VMG information is only available if your
unit is part of a SeaTalk or SeaTalk
which has a compatible wind instrument and
transducer connected.
1. Use the Speed button to cycle through the
available speed pages.
2. From the Maximum Speed page or Average
Speed page, press and hold the Reset button for
approximately 3 seconds to reset the reading.
1
4
45
Re s e t
45
Re s e t
3
S pe e d
S pe e d
2
60 5
55
50 3 10
15
40 20
35 25
30
S pe e d
60 5
55
50 3 10
15
40 20
35 25
30
D12539-2
ng network
65