Using Tridata Trip, Log, Temp And Timer; Using The Timers - Raymarine i50 Depth Installation And Operation Instructions Manual

8.11 Using Tridata trip, log, temp and
timer pages
To cycle through the trip, log, water temperature and
timer pages follow the steps below.
Trip
Trip
Trip
1. Press the Trip button to cycle through the Trip,
Log, Water temperature and Timer pages.
66

8.12 Using the timers

To cycle through and use the Race Timer pages and
Stop Watch page follow the steps below.
With a timer page displayed:
1. Press the Reset button to start the timer.
2. With the timer running, press the Reset button
to pause the timer.
3. With the timer running, press and hold the Reset
button for approximately 1 second to reset the
timer.
Trip
Note: After the race timers have counted down
to zero they will then start to count upwards from
zero.
Trip Setting the race timer
There are 2 race (count-down) timers. The race
timers can be set from 1 to 15 minutes.
Trip
1
D12540-2
With a Race Timer isplayed
1. Press the Trip and Reset buttons at the same
time to edit the timer.
2. Use the Reset button to increment the race timer
start value, or
3. Use the Trip button to decrease the race timer
start value.
4. Press the Trip and Reset buttons at the same
time to confirm the new value.
Note: After a Race Timer has counted down to
zero it will then start to count up.
Timer buzzer
The Timer buzzer is enabled or disabled during
calibration see the User calibration section.
When using a race timer with the timer buzzer
enabled, the buzzer will:
• Short double beep every minute.
• 3 Long beeps at the start of the last 30 seconds.
• Short beep once for each of the last 10 seconds.
• Long beep at zero.
2
Trip Re s e t
Trip
Re s e t
Re s e t
Trip
D12541-2
i50