Table of Contents
Advertisement
Under SNMP v1/v2c create a new
community.
Add the IP address of SNMP manager (in
the example, 192.168.1.114/32). If required,
change the query and trap ports to match
the SNMP manager.
You can add multiple SNMP managers or set
the IP address/Netmask to 0.0.0.0/0.0.0.0
and the Interface to ANY so that any SNMP
manager on any network connected to the
FortiGate unit can use this SNMP community
and receive traps from the FortiGate unit.
Enable the SNMP Events (traps) that you
need. In most cases leave them all enabled.
Enabling SNMP on a
FortiGate interface
Go to System > Network > Interfaces.
Enable SNMP administrative access on the
interface connected to the same network as
the SNMP manager.
38
The FortiGate Cookbook 5.0.
Advertisement
Table of Contents
