Mount Wheel; Battery; Safety Advices - Chery A3 User Manual

6. Place the jack so that the whole foot seat
surface is located on a firm ground.
7. The jack shall be jacked up vertically to the
jack-up point.
8. Jack up the vehicle until the wheel is above
the ground.
9. Loosen the wheel bolts to remove the wheel.

Mount Wheel

1. Push the wheel onto the wheel hub bearing to
align it with the bolt hole, screw on the wheel
bolt clockwise and make sure the pointed end
of the wheel nut faces the wheel.
2. Tighten the wheel nuts in diagonal sequence
for two or three times until they are fastened
110±10N•M).
(the tightening torque is
3. Lower the vehicle to remove the jack.
4. Replace the jack and the faulty wheel, and
secure them.
5. If possible, deliver the wheel to Chery
authorized service station to check the
tightening torque of the wheel bolt and the tyre
pressure.
6. Since the spare tyre may be in storage for a
long time, its tyre shall be inflated with a
pressure slightly higher than that of the
normally used tyre to ensure that the spare
tyre has standard pressure in it.
Parameters of Capacity and Specifications

Battery

Your vehicle is equipped with a 12V maintenance-
free lead-acid battery.

Safety Advices

While handling the battery, make sure
to take the following precaution measures.
●
The acid liquid of the battery is corrosive. Be
sure to wear gloves and goggles. Do not allow
your skin or clothing to come in contact with
acid or lead. Do not tilt the battery, for the acid
liquid may flow from the vent opening. If the
acid liquid splashes into your eyes, wash your
eyes immediately with clean water for several
minutes and then seek doctor's advice. If the
acid liquid splashes onto your skin or clothing,
60