“One-To-One” Service - Chery A3 User Manual

When the car is running, the too low engine speed
is also undesired. It is necessary to shift the lever
to the proper gear, as the case may be.
Given a cold car, do not have the engine working
at the maximum speed, despite the lever being set
in the neutral or a driving gear.
At beginning of use, a new tyre does not get the
best adhesive force. Therefore, even a new tyre
also needs running-in. Consequently, during the
first 100km, the car speed shall be kept low and
the driving shall be particularly careful.
A new brake friction wafer wants running-in as
well, for the brake does not have the ideal friction
within the first 200km. If the braking effect during
such a period seems poor, it is allowed to properly
increase the pressure on the pedal. This method is
also applicable every time you henceforth replace
the friction wafers with new ones.
Once a new car has traveled for 800km in total, it is
compulsory to retighten the wheel nuts to the
specified torques. See Chapter "Specification
Parameters" in this manual for these correct torque
values. For the car whose wheels have been
replaced or whose wheel nuts have been
loosened, it is also required to retighten these
wheel nuts to the specified torques as soon as the
car has run for 800km.
"One-to-one" Service
For the purpose of providing you with the better
service and car, the dealer under Chery will assign
a service consultant for you when you are buying a
Chery car. If you have any question during the
course of using the car, you can contact your
service consultant and he/she will present the best
service to you.
Drive Introduction
7