Boom Extension Cylinder - Genie S-80 Service And Repair Manual

Service and Repair Manual
Boom Components
4-4 4-4 Boom Extension C ylinder

Boom Extension Cylinder

The boom extension cylinder is located inside the
boom assembly and incorporates cables and
pulleys that are responsible for extending the
number 3 boom tube. The primary boom extension
cylinder is equipped with counterbalance valves to
prevent movement in the event of a hydraulic line
failure.
How to Remove the Boom
Extension Cylinder
Bodily injury hazard. This
procedure requires specific repair
skills, lifting equipment and a
suitable workshop. Attempting
this procedure without these
skills and tools could result in
death or serious injury and
significant component damage.
Dealer service is strongly
recommended.
Note: When removing a hose assembly or fitting,
the O-ring (if equipped) on the fitting and/or hose
end must be replaced. All connections must be
torqued to specification during installation. Refer to
Specifications, Hydraulic Hose and Fitting Torque
Specifications.
Note: Perform this procedure with the boom fully
retracted.
1 Raise the boom to a horizontal position.
2 Remove the boom end cover retaining
fasteners and remove the cover.
3 Remove the access covers from both sides of
the boom at the pivot end.
40
4 Fully loosen the lock nuts on the extend
cables. Do not remove the nuts.
1 cable guard
2 retaining block
5 Loosen the retract cable nut at the platform
end of the boom. Pull the cable rod from the
support and let it hang down.
6 Remove the cable guard fasteners and
remove the cable guard.
7 Locate the retaining plates that secure the
retract cables to the inside of the number
3 boom tube.
8 Remove the cable retaining plates and pull
the retract cables off of the pulleys. Lay the
cables flat and out of the way.
S-80 • S-85 • S-80X
September 2015
Part No. 1269074