Linefeed; Calibration Parameters - Fluke 7102 User Manual

d=FULL
The mode may be changed using "UP" or "DOWN" and pressing "SET".
d=HALF

9.8.2.4 Linefeed

The final parameter in the serial interface menu is the linefeed mode. This
parameter enables (on) or disables (off) transmission of a linefeed character (LF,
ASCII 10) after transmission of any carriage-return. The linefeed parameter is
indicated by,
LF
LF= On
The mode may be changed using "UP" or "DOWN" and pressing "SET".
LF= OFF
9.8.3

Calibration Parameters

The operator of the Micro-Bath controller has access to a number of the bath
calibration constants namely R0, ALPHA, DELTA, C0, CG, and rCAL. These
values are set at the factory and should not be altered. The correct values are
important to the accuracy and proper and safe operation of the bath. Access to
these parameters is available to the user only so that in the event that the
controller memory fails the user may restore these values to the factory settings.
The user should have a list of these constants and their settings with manual.
The calibration parameters menu is indicated by:
CAL
Press "SET" five times to enter the menu.
The calibration parameters R0, ALPHA, DELTA, C0, CG, and rCAL characterize
the resistance-temperature relationship of the platinum control sensor. These
parameters may be adjusted by an experienced user to improve the accuracy of
the calibrator.
Find Quality Products Online at:
Current duplex mode setting
New duplex mode setting
Flashes "LF" and then displays the setting
Current linefeed setting
New linefeed setting
DO NOT change the values of the bath calibration constants
from the factory set values. The correct setting of these
parameters is important to the safety and proper operation of
the bath.
Calibration parameters menu
GlobalTestSupply
www.

Caution:
.com
Controller Operation
9.8 Controller Configuration
9-11
sales@GlobalTestSupply.com
9