High Limit; Stir Speed; Serial Interface Parameters - Fluke 7102 User Manual

9.8.1.1 High Limit

The High Limit Parameter adjusts the upper set-point temperature. The factory
default and maximum temperature are set to 126 °C. For safety, a user can
adjust the HL down so the maximum temperature set-point is restricted.
HL
Press "SET" to enable adjustment of HL
HL
H=126
Adjust the HL parameter using "UP" or "DOWN"
H=90
Press "SET "to accept the new temperature limit.

9.8.1.2 Stir Speed

The Stir Speed parameter adjusts stirrer motor speed. The factory default is 20.
Str SP
0
To change the stir speed press "UP" or "DOWN".
16
Press "SET" to accept the new Stir Speed.
The stir motor speed needs to be varied for best stability. Table 3 on page 25
shows nominal settings for several fluids.
9.8.2

Serial Interface Parameters

The serial RS-232 interface parameters menu is indicated by,
SErIAL
The serial interface parameters menu contains parameters which determine the
operation of the serial interface. These controls only apply to instruments fitted
with the serial interface. The parameters in the menu are — baud rate, sample
period, duplex mode, and linefeed. Press "UP" to enter the menu.
Find Quality Products Online at:
High Limit parameter
Flashes "HL" and then displays the setting
Current HL setting
New HL setting
Flashes "Str Sp" and then displays the setting
Current Stir Speed setting
New Stir Speed setting
Serial RS-232 interface parameters menu
GlobalTestSupply
www.
Controller Operation
9.8 Controller Configuration
.com
sales@GlobalTestSupply.com
9
9-9