Installation - Secura Key SK-ACPE User & Installation Manual

SK-ACPe
CAUTION SHOULD BE TAKEN NOT TO TOUCH CIRCUIT BOARD OR ELECTRONIC COMPONENTS PRIOR
TO AND DURING INSTALLATION TO AVOID ELECTRO-STATIC DISCHARGE (ESD) DAMAGE.
INSTALLING THE SK-ACPE
1. Select a location for the SK-ACPE unit that is secure and sheltered from weather and extreme humidity.
Choose a location that facilitates access to power and is reasonably close to the doors that are to
be controlled (no further than 500 feet).
2. Using the unit as a template, mark on the mounting surface the location of the four mounting holes.
3. Install appropriate mounting hardware (anchors, retainers, etc.) to the mounting surface if necessary.
4. Screw #6 or #8 mounting screws
into the top 2 mounting holes of
the mounting surface, leaving
about 1/4" clearance.
5. Place panel top key-way mounting
holes over installed mounting
screws and slide panel down.
6. Tighten top mounting screws.
7. Install two bottom mounting screws
(see figure 2).
8. Route cables into the enclosure
through knockouts in sides or back
of box, being careful not to nick
or scrape insulation on any rough
edges.
InStAllAtIon & oPerAtIng MAnuAl

INSTALLATION

figure 2
3