Secura Key SK-ACPE User & Installation Manual page 24

SK-ACPe
Hardware Connection
You must connect a Windows computer COM port to the J11 port on each SK-ACPE, using the
RS-232E cable (or to J7 using a wire pigtail, see Figure 3). If your computer does not have a
serial COM port, purchase and install the SK-USB USB-to-Serial Converter on your computer,
and connect the DB9M connector on the converter to the DB9F connector on the RS-232E cable.
You can configure the Ethernet adapter by either using SK-NET™ Terminal, which is included with
the SK-NET™ software or by using HyperTerminal.
Configuring the SK-ACPE Using SK-NET™ Terminal
Follow these steps to configure your SK-ACPE.
1. Connect your computer to the SK-ACPE being configured.
2. Start SK-NET™
3. Right click on the Connection 1
4. Select Properties
5. Select the Connection tab
6. Select Edit
7. Select Test. The SK-ACPE Log On Screen displays (Fig D-1)
8. Type in the Default Password 12345 and press Enter. The Device Configuration Screen (Fig
D-2) will display: Ignore any IP addresses currently displayed – these are random values.
9. At the prompt, you will enter data for items 1, 2, 3, and 4:
10. Type 1, then type in the static IP address provided by the system administrator. Press Enter,
then press Y to save changes.
11. Type 2, then type in the subnet mask provided by the system administrator. Press Enter,
then press Y to save changes.
12. Type 3, then enter the default Gateway provided by the system administrator. Press Enter,
then press Y to save changes.
13. Type 4, then enter the DNS server provided by the system administrator.
14. Press Enter, then press Y to save changes.
15. Press ESC to exit, and the configuration is done. Your control panel is ready to connect to
the LAN.
16. Enter the IP address settings for each SK-ACPE into the SK-NET™ Properties screen for each
Ethernet-connected panel.
InStAllAtIon & oPerAtIng MAnuAl
D-2