Nokia 6111 RM-82 Service Manual page 95

RM-82
Service tools and concepts
Issue 1
PCS-1
The PCS-1 power cable (DC) is used with a docking station, a module
jig or a control unit to supply a controlled operating voltage.
PKD-1
SW security device is a piece of hardware enabling the use of the
service software when connected to the parallel (LPT) port of the PC.
Without the device, it is not possible to use the service software.
Printer or any such device can be connected to the PC through the
device if needed.
RJ-104
RJ-104 is a rework jig used when servicing the BTHFM module. It is
used together with rework stencil ST-37.
RJ-98
The soldering jig RJ-98 is used for soldering and as a rework jig for the
main board. The material is resistant to the heat used by lead free
soldering.
The PWB can be used with either A or B side upwards.
SA-71
SA-71 RF Coupler is used for Go/No-Go test after changing components
in the RF part of the phone.
The SA-71 is mounted on the docking station adapter, after which the
phone can be placed in the docking station adapter.
Note: For RF loss values, please refer to the Service bulletin.
COMPANY CONFIDENTIAL
Copyright © 2005 Nokia. All rights reserved.
Power cable
SW security device
BTHFM rework jig
Soldering jig
RF Coupler
Nokia Customer Care
Page 4 –11