Phoenix Update Installation - Nokia 6111 RM-82 Service Manual

RM-82
Phoenix service SW
After the reboot, components are registered and Phoenix is ready for use.
Note: Phoenix does not work, if components have not been registered.
7. Click Finish to end installation.
Phoenix is now ready for use.
Next action
Before using Phoenix Service Software, you must:
• install phone model specific data package for Phoenix, and
• configure users and connections.
FPS-8* can be used after updating its Flash Update Package files.

Phoenix update installation

If you already have the Phoenix Service SW installed on your computer, sooner or later there will be need to
update it when new versions are released.
Always use the latest available versions of both the Phoenix Service SW and the phone-specific Data Package.
Instructions can be found in phone model specific Technical Bulletins and Phone Data Package readme.txt
files (shown during installation).
To update the Phoenix Service Software you need to take exactly the same steps as when installing it for the
first time:
Issue 1
Figure 17 Registering components 2
Figure 18 Finish installation
COMPANY CONFIDENTIAL
Copyright © 2005 Nokia. All rights reserved.
Nokia Customer Care
Page 3 –11