Table of Contents
Advertisement
RM-82
Phoenix service SW
Service software installation
Phoenix installation steps in brief
Phoenix is the DCT-4 generation service software for reprogramming, testing and tuning the phone.
To install Phoenix, you need to:
• Connect a DK2 Dongle or FLS-4S POS Flash Device
• Install the Phoenix Service SW
• Install the Data Package for Phoenix
• Configure users
• Manage connection settings (depends on the tools you are using)
Phoenix is now ready for FLS-4S Point Of Sales Flash Device use.
If you use FPS-8:
• Update FPS-8 SW
• Activate FPS-8
• Update JBV-1 Docking Station SW (only when needed)
Phoenix is now ready to be used with FPS-8 flash prommer and other tools as well.
The Phoenix Service Software installation contains:
• Service software support for all phone models included in the package
• Flash update package files for FPS-8* and FLS-4S programming devices
• All needed drivers for:
• DK2 dongle
• FLS-4S point of sales flash device
• USB devices
Note:
Separate installation packages for flash update files and drivers are also available, but it is
not necessary to use them unless updates appear between Phoenix Service SW releases. If separate
update packages are used, they should be used after Phoenix and data packages have been installed.
Supported operating systems
• Windows 2000 and XP.
Hardware requirements for using Phoenix
• Minimum: Processor 300 MHz, RAM memory 64 MB, disk space 100 MB.
• Recommended for Windows 2000: Processor 700 MHz, RAM memory 256 MB, disk space 150 MB.
Installing Phoenix
Before you begin
• Check that a Dongle is attached to the parallel port of your computer.
• Download the installation package (for example,
C:\TEMP , for instance).
computer (in
• Close all other programs.
Issue 1
phoenix_service_sw_a15_2004_24_7_55.exe ) to your
COMPANY CONFIDENTIAL
Copyright © 2005 Nokia. All rights reserved.
Nokia Customer Care
Page 3 –5
- Quick Links:
- Phone Features
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
