Test Procedure - Nokia RM-57 Service Manual

RM-57/58
BB Troubleshooting and Manual Tuning Guide
When measuring with a single-ended probe each output is measured against the ground.
Internal handsfree output is measured using a current probe, if a special low-pass filter designed for measuring
a digital amplifier is not available. Note also that when using a current probe, the input signal frequency must
be set to 2kHz.
The input signal for each loop test can be either single-ended or differential.
Required equipment
The following equipment is needed for the tests:
• Oscilloscope
• Function generator (sine waveform)
• Current probe (Internal handsfree DPMA output measurement)
• Phoenix service software
• Battery voltage 3.7V

Test procedure

Audio can be tested using the Phoenix audio routings option. Three different audio loop paths can be activated:
• External microphone to Internal earpiece
• External microphone to Internal handsfree speaker
• Internal microphone to External earpiece
Each audio loop sets routing from the specified input to the specified output enabling a quick in-out test. Loop
path gains are fixed and they cannot be changed using Phoenix. Correct pins and signals for each test are
presented in the following table.
Phoenix audio loop tests and test results
The results presented in the table apply when no accessory is connected and battery voltage is set to 3.7V.
Earpiece, internal microphone and speaker are in place during measurement. Applying a headset accessory
during measurement causes a significant drop in measured quantities.
The gain values presented in the table apply for a differential output vs. single-ended/differential input.
Loop test
External Mic to External
Earpiece
Issue 1
Input terminal Output
terminal
XMICP and GND HSEAR R P,
HSEAR R N
and GND
HSEAR P,
HSEAR N and
GND
XMICN and GND HSEAR R P,
HSEAR R N
and GND
HSEAR P,
HSEAR N and
GND
Company Confidential
Copyright ©2005 Nokia. All Rights Reserved.
Path Input Different
gain [dB] voltag ial
(fixed) e output
[mVp- voltage
p] [mVp-p]
-2.9 1000 720
Nokia Customer Care
Outpu Outp
t DC ut
level curre
[V] nt
[mA]
1.2 NA
Page 6–49