Turning Each Channel Of The Song On/Off - Yamaha Tyros5-76 Owner's Manual

Using Markers in Loop Playback
In this section, we'll explain loop playback by the example of looping between markers SP 1 and SP 2.
1
Press the [PLAY/PAUSE] button to start playback from the top
of the Song.
2
After passing the [SP 1] point, press the [LOOP] button to turn
the loop function on.
The Song plays back up to the [SP 2] point, then goes back to [SP 1] and loops
between the two points.
Top of
[SP 1]
the song
3
To turn the loop function off, press the [LOOP] button again.
When you turn it off, playback continues past the [SP 2] point.

Turning Each Channel of the Song On/Off

1
Press the [CHANNEL ON/OFF] button a few times to call up the
CHANNEL ON/OFF (SONG) display.
2
Use the [1 ]–[8 ] button to turn each channel on or off.
If you want to play back only one particular channel (solo playback), press and
hold down one of the [1 ]–[8 ] buttons corresponding to the desired
channel. Only the selected channel is turned to on and others are off. To cancel
solo playback, press the same button again.
3
Press the [EXIT] button to close the CHANNEL ON/OFF display.
[SP 2] [SP 3]
End of
[SP 4]
the song
2
NOTE
The Voice for each channel can be
changed from the VOL/VOICE page of
the MIXING CONSOLE display
(page 93).
Tyros5 Owner's Manual
4
75