Check Before Starting; Starting And Stopping - McCulloch B33 P Operator Instructions Manual

Check before starting

formed at the bottom of the teeth or by the center
blade if cracks are found.
fatigue or due to being tightened too much. Discard
1.5 Nm. The tightening torque of the locking nut
must be 35-50 Nm.
Check that the blade guard is not damaged or
cracked. Replace the blade guard if it is exposed to
impact or is cracked.
Check that the trimmer head and trimmer guard are
not damaged or cracked. Replace the trimmer head or
are cracked.
before you start the unit.

Starting and stopping

a
WARNING:
personal injury.
surface. Ensure the cutting attachment cannot
Make sure no unauthorized persons are in the
personal injury. The safety distance is 15 meters
STARTING AND STOPPING
11
Cold engine
1.
position.
Press the primer bulb 10 times. The primer bulb
does not need to be completely full of fuel.
3.
position.
4.
5. Hold the body of the unit on the ground using your
left hand (CAUTION:
your right hand until you feel some resistance (the
around your hand.
6.
the engine attempts to start.
position.
9.
the engine starts.
NOTE! Do not pull the starter cord all the way out
and do not let go of the starter handle when the
cord is fully extended. This can damage the unit.
a
WARNING:
10.
up for 60 seconds.
Warm engine
1.
position.
Press the primer bulb 10 times. The primer bulb
does not need to be completely full of fuel.
3.
position.
4.
the engine starts.
Stopping
CAUTION:
In order to prevent unintentional
starting, the spark plug cap must be removed from
the spark plug when assembling, checking and/or
performing maintenance.