Paxar TC6021OH Operator's Handbook Manual page 17

3. Place the roll of supplies between the hubs. Rotate the
dust cover forward slightly , so the hubs lock into the core
of the roll. Make sure the supply turns freely on the hubs.
4. Hold the printer upright. In one quick release action, slide
both latch buttons, one on each side of the printer, to the
rear (Figure 4). The platen carrier will partially open.
Guides
Latch
Button
Feed Label
Strip Here
5. Feed the label strip into the printer until it comes out the
front and over the metal roller.
6. Close the dust cover completely.
Metal
Roller
Figure 4
2. Getting Started
Platen
Carrier
9