Program Scan; Scan; Confirming Start And End Frequencies; Scan Hold - Kenwood TS-50S Instruction Manual

5 SCAN
PROGRAM SCAN
SCAN
Press the SCAN button while in the VFO mode, and
the transceiver scans upwards from the current
operating frequency. Hold the microphone DWN
button to scan downwards. Releasing the microphone
DWN button causes the scan to resume upwards.
If no data is stored in channel 99, the following data
will be automatically stored in that channel when you
press the SCAN button:
Start frequency: 30.0 kHz
End frequency: 29.999.9 MHz
Scan will ascend from the current operating frequency
and scan the above range.
If the scan range stored in channel 99 does not
include the current operating frequency, scan will jump
to the start frequency and begin to scan.
A If channel 99 contains no data:
1 Press the SCAN button.
2
Scan ascends from the currently displayed
frequency. The scan range will be 30 kHz to
29.999.9 MHz.
Modulation settings and frequency can be
changed during scan. To change frequency,
use the tuning control, or the microphone UP
and DWN buttons.
3 To stop scan, press the SCAN or CLR button,
or press the microphone PTT button
momentarily.
B If channel 99 contains data:
39
Example: 14.000 MHz (start) and 14.010 MHz
(end) have been stored in channel 99.
Press the SCAN button, and scan will cycle in the
stored frequency range.
CONFIRMING START AND END
FREQUENCIES
Start and end frequencies stored in memory channel
99 may be confirmed using this procedure:
1 Press the M/V button to change from VFO to
Memory Channel mode. The last memory channel
number selected appears.
2
IU"US"
I
I.U
1 .L'kH<
M.~
I 'I
9'04050d11
• g
a
'0 CW
Select memory channel 99 using the UP or
DOWN button.
Example: 7.030 MHz is stored in memory channel
99.
'" SLOW
M.CH
I i " : ! " "
I. U ..J U. U ,",
9 .0 .., 500& PRG
4 6 e 1 0 LSB
3 Press the F.LOCK button, and the F.LOCK
indicator appears.
'"
SLOW FLOCK
M.CH
""3""
I. U U. U ,",
'39
9 ""
4(]
so.e
PRe
4 6 B '0 LSB
4 Display the start frequency by pressing the DOWN
button, and the end frequency by pressing the UP
button.
S Switch the F.LOCK button off to change the
operating frequency using the tuning control.
6 To return to the VFO mode, switch the F.LOCK
off and press the M/V button, or press the M
>
V
button to transfer the memory data to the VFO.
SCAN HOLD
Turn the tuning control during program scan with Scan
Hold on. and scan will stop on the current frequency,
and then resume a short time later. Turn off the Busy-
Frequency Stop funct'lon for program scan (Menu A,
No.9) to use Scan Hold.
To enable this function, refer to Menu Set-up (Menu
B. No. 58) on page 47.
Note:
If
either the AT-50 or AT-30G antenna tuner is
connected to the transceiver. pressing the A T TUNE button while
scanning halts scan. With no tuner connected, scan is not
affected.