Reconnecting The Battery - Ferrari 488GT Owner's Manual

Detach the terminal from the battery and place it on hook D. in this
way, the power supply from the battery to the electrical system is
cut off.
Warning
The battery quick release connector may only be used by
qualified personnel, should it not be possible to connect the
battery conditioner.
The battery is in integral component of the vehicle, and
required the vehicle itself to be used frequently in order to
function correctly. Infrequent vehicle usage may reduce battery
performance or result in complete battery failure.
Constant usage of the specific battery conditioner provided by
Ferrari for each model ensures that the original battery installed
in the vehicle is kept charged correctly and in working order.
Warning
Place the terminal so that it does not come into contact with the
battery terminal or other metal parts of the vehicle.
C

Reconnecting the battery

Take the terminal off hook D, place it on the battery and fasten it
by closing the locking lever.
Each time the battery is reconnected, do the following before
starting the engine:
- close both doors and close the luggage compartment lid; unlock
- adjust the clock (date and time on instrument panel);
- close both doors and fully raise the driver side and passenger side
The Motronic ECU self-acquisition cycle will only function correctly
when the intake air temperature is above 5 °C (41 °F).
After removing the battery from the vehicle or disconnecting it
from the electrical system using the battery master switch, it is
important to check that the external temperature is within the
D
indicated values when reconnecting before performing the self-
acquisition cycle.
and lock the doors using the remote control; open the luggage
compartment lid using the remote control;
windows to their upper limit; check that the windows move down
to the "target position" when the doors are opened.
Warning
Before starting the engine, wait at least 60 seconds after
activating the instrument panel to allow the electronic system
that controls the motor-driven valves and the AC ECU to run a
self-acquisition process.
During this period, no devices must be activated.
Advice for Emergency Situations
4
225