Table of Contents
Advertisement
Fault priority levels
The simultaneous display of several faults follows a logic that
depends on the priority level assigned to it:
Priority level 0 - Critical fault.
Priority level 1 - Extremely critical fault.
Priority level 2 - Critical fault.
Priority level 3 - Non-critical fault.
When several fault events occur at the same time, faults with
priority level 0 are displayed first, followed by priority level 1 and
then priority levels 2 and 3. The information on the various faults is
displayed in turn for 5 seconds each.
If a fault message is being displayed and a second fault with the
same priority level occurs, the latter is only displayed once the first
has been displayed for at least 2 seconds. If, on the other hand,
a new fault occurs with a higher priority level, this is displayed
immediately.
About your Vehicle
102
Indication of failure of turn indicators and running lights
A failure of the running lights (front and/or rear) and turn
indicators (front and/or rear) is indicated in the same way as other
faults but the vehicle symbol with the faulty running light or turn
indicator indicated in red is displayed together with a description
of the failure instead of the "External lights failure" symbol (see
page 105). When the display cycle ends or the OK button with
"ESCAPE" function has been pressed, the "External lights failure"
symbol is minimised.
Lamp Failure
Advertisement
Table of Contents
