Cleaning The Sensors - Ferrari 488GT Owner's Manual

Table of Contents

Advertisement

If the front sensors are deactivated or not present, the display does
not show the symbols in the front. In the same way, if front sensors
are fitted and the rear ones are not activated, the display only
shows the symbols in the front. If all the sensors are activated, the
system can give several pieces of information at the same time: if
an obstacle is detected at a maximum distance in the front central
part and at a minimum distance in the rear right part, it will be
displayed as shown below.
If the parking sensor system symbols are being displayed and an
event occurs that needs to be displayed as an icon and/or special
message, the symbol is moved from the centre of the display to the
right as shown below.

Cleaning the sensors

When cleaning the sensors, be very careful not to scratch or
damage them and avoid using dry, rough or hard cloths.
The sensors must be washed with clean water and car shampoo
added if necessary. In car washes that use steam jet or high
pressure water cleaning equipment, quickly clean the sensors
keeping the nozzle at a distance of at least 10 cm.
For the repainting of bumpers or retouching the paintwork in
the sensor area, contact the Ferrari Service Network. If paint
is applied incorrectly, it may prevent the parking sensors from
working properly.
Catalysts temp.
too high
Engine
performance
limited
About your Vehicle
3
99

Advertisement

Table of Contents
loading

This manual is also suitable for:

488

Table of Contents