Table of Contents
Advertisement
Occasionally, the system may not detect which wheel signals
a failure. If this is the case, then only the message "Check tyre
pressure" will be displayed as shown in example 6.
Tyre puncture
Regardless of the current active page on the left TFT display, when
the instrument panel receives the signal from the tyre pressure
ECU that the pressure level of one or more tyres is below the alarm
threshold, the specific screen shown in example
to proceed) is displayed immediately. At the same time, a warning
light comes on on the panel (see page 107) in fixed mode.
Warning
If you have a puncture, stop driving
Example
6
7
(warning not
Example
7
The screen page is displayed for 20 seconds and then the screen
page that was previously displayed reappears whereas the warning
light on the instrument panel remains on in fixed mode.
The fault is displayed with the same display logic applicable for
other priority 0 faults (see the paragraph "Fault visualisation logic"
on page 101) until the correct operating conditions are restored
and the system is subsequently recalibrated.
If you call up the TYRES screen page, you can identify the
punctured tyre at any time (example 8).
Example
8
2
Safety
67
Advertisement
Table of Contents
