WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
To Remove the Rear Panel
1. Unplug dryer or disconnect power.
2. Remove drain hose from standpipe or laundry tub.
3. Remove the 5/16" hex-head screw securing the terminal
block cover to the rear panel. Remove the cover (see
Figure 1).
4. Remove the 1/4" hex-head screw securing the auxiliary
fan guard to the rear panel. Remove the fan guard (see
Figure 2).
Removing the Rear Panel
Figure 1
Figure 2
5. Remove the fifteen (15) 1/4" hex-head screws securing
the rear panel to the dryer (see Figure 3).
Sump Drain Port
6. Lift up rear panel up and away from dryer base and set
aside.
HybridCare™ Dryer with Heat Pump Technology
COMPONENT ACCESS
Terminal Cover
Auxiliary Fan Guard
Figure 3
n
4-15