Removing The Drum Light - Whirlpool WED99HEDW0 Technical Education

Removing the Drum Light & Outlet Thermistor
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
To Remove the Drum Light
1. Unplug dryer or disconnect power.
2. Perform the procedures on page 4-4, "Removing the Top
Panel" and "Removing the Console" prior to performing
the following steps.
3. Perform the procedures on page 4-7, "Removing the Front
Panel" prior to performing the following steps.
4. Depress the tabs on both sides of the drum light to
release from light from bulkhead. Push light and harness
through hole (see Figures 1 and 2).
Depress Tabs
Drum Light
Figure 1
Figure 2
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
To Remove the Outlet Thermistor
1. Unplug dryer or disconnect power.
2. Perform the procedures on page 4-4, "Removing the Top
Panel" and "Removing the Console" prior to performing
the following steps.
3. Perform the procedures on page 4-7, "Removing the Front
Panel" prior to performing the following steps.
4. Disconnect the two wire connectors from the outlet
thermistor terminals (red-white and yellow). See Figure 3
below.
5. Remove the screws from the outlet thermistor as
illustrated in Figure 3 and remove the component from
the blower housing.
HybridCare™ Dryer with Heat Pump Technology
COMPONENT ACCESS
Outlet Thermistor
1 - YELLOW Wire
1 - RD-WH Wire
Figure 3
n
4-9