Majestic MDVI30IN Installation Manual page 29

Log #2 (SRV2218-704): Note the location of the log pin placement holes on the bottom of Log #2, shown in Figure 6. Position
Log #2 by placing over the two log pins located on the surface of the burner. Figure 7 shows Log #2 installed.

Figure 6. Log #2 Detail
Log #3 (SRV2218-705): Note the location of the log pin placement hole and grate tine groove on the bottom of Log #3.
Position Log #3 as shown in Figure 9 by mating the hole on the bottom of Log #3 with the last log pin on the surface of the
burner, adjusting placement on the grate tine as necessary for correct orientation.
GRATE TINE GROOVE GRATE TINE GROOVE
Figure 8. Log #3 Detail
Log #4 (SRV2218-702): Note the fl at areas on Log #1 and Log #2 highlighted in Figure 7. Position Log #4 by placing the
left end of the log fully into the fl at area on Log #1. Set the other end of Log #4 in the fl at spot on Log #2. See Figure 12.
Note the differences between Log #4 and Log #6. Log #4 has bark across the entire back and a burnt section on the left,
whereas Log #6 is only partly covered by bark and the burnt section is in the center of the log. See Figure 10 and Figure 11.
Figure 10. Log #4 and Log #6 - Back Views
3 3
Figure 12. Log #4 installed
Majestic • MDVI30IN, MDVI35IN, MDVI30IL, MDVI35IL Installation Manual • 2205-980 Rev. H • 12/16
LOG PIN HOLES LOG PIN HOLES
LOG PIN HOLE LOG PIN HOLE
LOG #4 LOG #4
LOG #6 LOG #6
4 4
1 1
2 2
FLAT AREAS FOR LOG #4 FLAT AREAS FOR LOG #4
1 1
Figure 7. Log #2 Installed
FLAT AREAS FOR LOG #6 FLAT AREAS FOR LOG #6
1 1
3 3
LOG GROOVE CONTACTS GRATE TINE LOG GROOVE CONTACTS GRATE TINE
Figure 9. Log #3 Installed
LOG #4 LOG #4
LOG #6 LOG #6
Figure 11. Log #4 and Log #6 - Front Views
2 2
2 2
29