Cleaning The Brew Group - Saeco Intelia Deluxe HD8906 Manual

ENGLISH
12
Interruption of the descaling cycle
Once the descaling cycle has started, you must complete it till the very end without turning off the
machine. In case you get stuck during the cycle or in case of power failure or accidental
disconnection of the power cord, you can exit by pressing the standby button. If this occurs, empty
and rinse carefully the water tank, then fill it up to the CALC CLEAN level. Follow the instructions
in chapter 'First installation', section 'Manual rinsing cycle' before brewing any beverage. If the cycle
was not completed, the machine will require another descaling cycle to be performed at your
earliest convenience.
Cleaning and maintenance

Cleaning the brew group

Clean the brew group once per week. Check the online manual for more detailed information
about the monthly cleaning of the brew group.
1 Remove the coffee grounds container and open the service door.
2 Remove the coffee residues drawer (Fig. 25).
3 To remove the brew group, press the lever and pull the brew group out of the machine
(Fig. 26).
4 Rinse the brew group with fresh water.
5 To place the brew group back, make sure that the lever is in contact with the base of the
brewing unit (Fig. 27).
Note: If it is not in contact with the base, push it down.
6 Make sure the locking hook of the brew group is in the correct position.
To position the hook correctly, push it upwards until it is in uppermost position (Fig. 28).
7 The hook is not correctly positioned if it is still in bottommost position (Fig. 29).
8 Slide the brew group back into the machine along the guiding rails on the sides until it clicks
into position. Then place the coffee residues drawer back in the machine.
Lubrication
Lubricate the brew group after approximately 500 cups of coffee or once a month.
1 Apply some lubricant around the shaft in the bottom of the brewing unit. (Fig. 30)
2 Apply lubricant to the rails on both sides, as shown in the illustration. (Fig. 31)
3 Slide the brew group back into the machine along the guiding rails on the sides until it clicks
into position. Then place the coffee residues drawer back in the machine.
Milk carafe quick clean
Between brewing milk varieties you can rinse the spout with hot water to make sure every milk
recipe is optimal.
1 Place a cup or container under the spout to collect the water.
2 Turn the milk dispensing spout to the 'I' position.
3 Press the CARAFE QUICK CLEAN button.