Saeco Intelia Deluxe HD8906 Manual page 8

ENGLISH
8
18 The display shows the filter ready icon to indicate the AquaClean filter has been installed
correctly (Fig. 14).
19 To rinse the filter, press the SPECIAL DRINKS button and select the HOT WATER option
and press the OK button twice. Water flows out from the hot water dispensing spout.
Discard this water.
Note: It can take a while until water comes out of the hot water dispensing spout. The filter needs to be
fully filled and rinsed with water.
The machine is ready for use.
Note: After installing the AquaClean filter, you do not have to perform the manual rinsing cycle.
Manual rinsing cycle
1 Place a container under the hot water dispensing spout.
2 Press the AROMA STRENGTH button to select pre-ground coffee. Do not add pre-ground
coffee.
3 Press the ESPRESSO or ESPRESSO LUNGO button. The machine starts dispensing water.
4 When the machine stops dispensing, empty the container. Repeat steps 1-3 twice.
5 Press the SPECIAL DRINKS button. Place a container under the hot water dispensing spout.
6 Press the UP/DOWN buttons to scroll through the options of the display. Press the OK
button to select 'hot water'.
7 Press the OK button to start hot water dispensing.
Dispense water until the display shows the no water icon.
,
8 Fill the water tank with fresh water up to the MAX level and remove the container.
The machine is ready for use.
AquaClean filter
The AquaClean filter is designed to reduce limescale deposits in your coffee machine and provide
filtered water to preserve the aroma and flavour of each cup of coffee. Using 8 AquaClean filters
correctly allows you to descale your machine every 2 years only, or every 5000 cups (with 100 ml
capacity)
AquaClean filter installation
Note: Your machine has to be completely limescale-free before you start to use the AquaClean filter.
If you did not activate the filter upon first use and brewed more than 50 cups (with 100 ml capacity),
you need to descale the machine before you activate the filter.
1 Remove the AquaClean filter from its packaging. Shake the filter for about 5 seconds.
2 Immerse the filter upside down in a jug with cold water and wait until no more air bubbles
come out. (Fig. 10)
3 Remove the water tank from the machine and insert the filter vertically onto the filter
connection. (Fig. 11)
4 Fill the water tank with fresh water and slide it back into the machine.
5 Press the MENU button and scroll to the AquaClean filter option. Then press the OK button
to select the AquaClean filter option.
Note: If you are installing the filter at first time use, follow the steps in chapter 'First installation'.