Machine Cleaning; Machine Cleaning When Needed; Weekly Cleaning Of The Machine; Brew Group Cleaning - Saeco Incanto HD8911/02 Instruction Manual

Hide thumbs Also See for Incanto HD8911/02:
Table of Contents

Advertisement

Available languages

Available languages

Maintenance schedule
When needed chapter no.
Weekly
chapter no.
Monthly
chapter no.
7.1

Machine cleaning

7.1.1

Machine cleaning when needed

>
>
>
>
>
7.1.2

Weekly cleaning of the machine

>
>
7.2

Brew group cleaning

7.2.1

Weekly brew group cleaning cycle

>
>
>
>
>
>
Damages or improper use caused by cleaning and maintenance activities are NOT
covered by the warranty.
Machine
Water tank
7.1.1 ; 7.5
7.3.1
7.1.2
When the 'Coffee grounds drawer full' symbol is displayed, proceed as follows.
Burning hazard! Before cleaning the machine, check that the machine, the grounds and
the water in the tank have cooled.
These processes must be launched every time the 'drip tray full' indicator raises. If
the indicator is completely raised, this means that the tray is full: be careful when you
remove it.
With the machine turned on, empty and clean the coffee grounds drawer and the
drip tray.
If the machine is turned off, once turned on the 'Coffee grounds drawer full' signal is
still on. Please refer to the "9.4 Troubleshooting table".
Press the side buttons.
Remove the drip tray.
Remove the coffee grounds drawer and empty it.
Empty and wash the drip tray.
Put the coffee grounds drawer in the drip tray and put the latter back into the machine.
Further maintenance operations can be carried out only when the machine is turned
off and disconnected from the power grid.
Follow the step-by-step instructions in the "7.1.1 Machine cleaning when needed"
chapter until you reach the seat of the drip tray. Now clean the drip tray seat.
Place the components back.
The brew group must be cleaned at least once a week.
Weekly cleaning of the brew group is a cleaning cycle with water (accurate rinsing).
Disassembly and cleaning phase
Turn the machine off with the STAND-BY button. Wait for the STAND-BY button to
start flashing and disconnect the power cord plug.
Press the side buttons.
Remove the drip tray.
Open the service door.
To remove the brew group:
• Place the thumb on the PUSH button and then the other fingers, on the handle.
• Press the PUSH button and pull the handle.
Remove horizontally without rotating it.
Coffee
Brew group
compartments
7.2.1
7.3.2
7.2.2 ; 7.2.3
Milk frother
7.4.1
7.4.2
11
ENGLISH

Advertisement

Table of Contents
loading

Table of Contents