Specifications; Input Characteristics; Speakers (Model 600S); Output Characteristics - Yamaha STAGEPAS 600i Service Manual

SPECIFICATIONS

General Specifications
Maximum Output Power (SPEAKERS L/R)
340 W + 340 W/4 Ω @Dynamic at 1 kHz
280 W+280 W/4Ω @10 % THD at 1 kHz
≧ 230 W+230 W/4Ω @1 % THD at 1 kHz
Frequency Response
-3 dB, +1 dB @ 40 Hz-20 kHz, 1 W Output/4Ω
(without EQ and SP EQ) (SPEAKERS L/R)
-3 dB, +1 dB @ 40 Hz-20 kHz, +4 dBu 10 kΩ Load
(MONITOR OUT)
Total Harmonic Distortion
≦ 0.5 % @20 Hz-20 kHz, +11 dBu 10 kΩ (MONITOR OUT)
Hum & Noise (Rs= 150 Ω, MIC/LINE switch=MIC)
≦ -113 dBu Equivalent input noise (CH1-4)
≦ -58 dBu Residual output noise (SPEAKERS L/R)
Crosstalk (1 kHz)
≦ -70 dB between input channels
Phantom Voltage
+30 V (CH1, 2)
Weight
25.4 kg (56 lbs) (Speaker 10.8 kg x 2 + Mixer 3.8 kg)
Package Contents
STAGEPAS 600i (includes two MODEL 600S Speakers and a
Powered Mixer), Cover Panel, Power Cord (2m), two Speaker
Cables (6m), 12 Non-Skid Pads, Owner's Manual
Power Consumption
35 W (Idle), 100 W (1/8 Power)

Input Characteristics

Input Terminals MIC/LINE
MIC
CH IN 1-2 XLR
LINE
MIC
XLR
LINE
CH IN 3-4
MIC
Phone
LINE
CH IN 5/6 Phone -
Phone -
CH IN 7/8
Pin -
Phone -
CH IN 9/10
Mini -

Output Characteristics

Output Terminals
Impedance
SPEAKERS OUT [L,R]
MONITOR OUT [L,R]
SUBWOOFER OUT
0 dBu=0.775 Vrms, 0 dBV=1 Vrms
Phone*: Unbalanced
Input Source
Impedance Impedance
3 kΩ 150 Ω Mics
3 kΩ 150 Ω Mics
10 kΩ 150 Ω Lines
(Hi-Z 1 MΩ) (Hi-Z 10 kΩ)
10 kΩ 150 Ω Lines
10 kΩ 150 Ω Lines
10 kΩ 150 Ω Lines
10 kΩ 150 Ω Lines
10 kΩ 150 Ω Lines
Output Load
Impedance
<0.1 Ω 4 Ω Speakers
600 Ω 10 kΩ Lines
150 Ω 10 kΩ Lines
Power Requirement
100 V - 240 V 50 Hz/60 Hz
Input Channel Equalization
±15 dB
HIGH: 8 kHz shelving
MID: 2.5 kHz peaking
LOW: 100 Hz shelving
Supported iPod/iPhone models (as of August 2012)
iPod touch (1st, 2nd, 3rd, and 4th generation), iPod classic,
iPod nano (2nd, 3rd, 4th, 5th, and 6th generation), iPhone
4S, iPhone 4, iPhone 3GS, iPhone 3G, iPhone For updated
information, check the Yamaha Pro Audio website
(http://www.yamahaproaudio.com/).

Speakers (MODEL 600S)

Enclosure
2 way bass-reflex type
Speaker Unit
LF: 10" (25 cm) Cone
HF: 1.4" (3.56 cm) Compression Driver
Crossover Frequency
2.8 kHz
Frequency Range
55 Hz-20 kHz (-10 dB)
Maximum Output Level
129 dB SPL (Measured peak IEC noise@1 m)
Coverage Angle
90° (Horizontal)/60 ° (Vertical)
Input Level
Sensitivity Nominal
-56 dBu -35 dBu
-30 dBu -9 dBu
-56 dBu -35 dBu
-30 dBu -9 dBu
-50 dBu -29 dBu
-24 dBu -3 dBu
-24 dBu -3 dBu
-24 dBu -3 dBu
-24 dBu -3 dBu
-24 dBu -3 dBu
-24 dBu -3 dBu
Output Level
Max. before
Nominal
Clipping THD+N 10%
62.5 W 230 W
+4 dBu +20 dBu
-3 dBu +17 dBu
STAGEPAS 600i
Connector Type
Max. before
Clipping
-10 dBu
+16 dBu
-10 dBu
+16 dBu
XLR Combo
-4 dBu
+22 dBu
+22 dBu
+22 dBu
+22 dBu
+22 dBu
+22 dBu Stereo Mini
Connector Type
Typ at
Dynamic
280 W 340 W
- -
- -
XLR-3-31
Phone*
Phone*
RCA Pin
Phone*
Phone*
Phone*
Phone*
3