Acura 2010 ZDX Owner's Manual page 560

Hide thumbs Also See for 2010 ZDX:

Table of Contents

Replacing a Daytime Running

1. Open the hood.

To change the bulb on the driver's

side, remove the clips by pushing

the center of the clips. Lift the

grommet over the stud bolt and

rotate the heat shield

counterclockwise.

To change the bulb on the

passenger's side, remove the

power steering fluid reservoir by

pulling it out of its stay.

2. Remove the front bulkhead cover

and engine compartment covers

(see page 544).

3. Remove the electrical connector

from the bulb by pushing on the

tab and pulling the connector

4. Remove the bulb by turning it one-

quarter turn counterclockwise.

5. Install the new bulb into the hole,

and turn it one-quarter turn

clockwise to lock it in place.

6. Push the electrical connector back

onto the bulb. Make sure it is on

all the way.

7. Test the lights to make sure the

new bulb is working.

8. Reinstall the front bulkhead cover

and engine compartment covers.

On the driver's side

Reinstall the heat shield.

On the passenger's side

Reinstall the power steering fluid